Airport Applications

When Indoor Air Quality Matters, Call Genesis Air

With constant foot traffic and high volumes of people, poor indoor air quality is common in airports. A PCO unit from Genesis Air is the perfect solution for airports looking to improve their indoor air quality and remove any unwanted odors from their halls.

Genesis Air is the ideal choice for airports because it addresses three major concerns you might have when choosing a PCO provider:

Sustainability

Our panels do not require monthly or even quarterly maintenance. Our system will last longer than the competition without needing to be replaced or maintained, saving you on operating costs.

Lifecycle Costs

Further decreasing operating costs, some parts of our units can be cleaned and reused rather than totally replaced.

Integrity of Design

Our products are designed with efficiency in mind. IAQ equipment from Genesis Air is built to last, and our POC units can be found in some of the biggest and busiest airports on earth.

Where We Are Improving IAQ

  • JFK International – NY
  • LAX – CA
  • Pittsburgh International Airport – PA
  • San Francisco Airport – CA
  • Many more

Recommended Products:

CU Edited.png

2008 CU

2008 CU unit is designed to be installed in the supply ductwork of any rooftop or air handling unit downstream of the particulate filtration and after the evaporator coil. Installation must be completed by qualified service personnel. This unit may be used in conjunction with a filter grill on the return or on the supply duct.

Spec Sheet | Installation and Operations Manual | Applications Guide

Edited B unit corner view.png

2008 B (1-4)

Stand alone unit or duct work attached and used as an air handler to conceal the unit above the ceiling space.

Features

  • Non-ozone producing lamps
  • 1 Merv 13Filter 20” x 24” x 4”
  • 3-UVGI Lamps per PCP Panel
  • Scalable up to 4 PCP Panels
  • Size: W22.5” x H30.25” x L44.5”
  • Weight 163/174/185/197 lbs
  • Voltage: 120-60 hertz
  • Amps: 6.5 / 7.6 / 8.7 / 9.8
  • CFM: 2280
  • Variable Speed Control
  • Standard: caster, handles and powder coated: mock rock

Spec Sheet | Installation and Operations Manual | Applications Guide

Edited DT FP.png

2008 DT FP

The Genesis Air 2008DT-FP is a stand-alone unit. The unit is utilized as a ducted application for permanent installations. This unit will clean and recirculate the air in a room without disrupting the HVAC system.

Features

  • Non-ozone producing lamps
  • 3 - 20” 30 Watt UV Lamps
  • Filter Merv 13 20” x 20” x 4”
  • Voltage: 115 60 hertz
  • Amps: 4.7
  • Airflow: 830 cfm
  • Return: 23.5in x 23.5in x 4in Drop Tile Grill

Spec Sheet | Installation and Operations Manual | Applications Guide

2008 pcp compound.jpg

2008 PCP Compound

The 2008 PCP Compound utilizes the entire airstream when installed in either the duct work or in the most accepted location--the air handler itself. The Genesis Air PCP Compound Photocatalyst System is used to reduce airborne biologics and VOCs in an airstream. In many cases, it's a convenient choice for gas phase filtration in place of adsorbent systems. With a .05 pressure drop across the catalyst at 500 fpm you don't have the traditional pressure drop you see in charcoal bed systems. And with a 15-year catalyst life, life cycle costs are considerably reduced with the PCP series.

Features

  • .05 inches of pressure drop @ 500 fpm
  • 15-year catalyst lifespan
  • Renewable Surface
  • No Ozone
  • Third Party Tested
  • UL, EPA certificates
  • 120 volts 60 hrtz Contact engineering for amp draw specs

Spec Sheet | Installation and Operations Manual | Applications Guide

Start Improving Your Indoor Air Quality